A quick hand - by - hand guide to standard applications of orbital motor

Cycloid hydraulic motor is an actuator of the hydraulic transmission system, is a hydraulic control valve to promote the rotation of machine equipment components, that is to say, he is equivalent to the body hand, is to undertake the implementation of the body CD command components. Many people do not understand the cycloid hydraulic motor, in fact, for many consumers, if you master the internal structure of the motor that is very good, but for the novice, we only need to master the cycloid hydraulic motor brick and transfer is enough.

First, cycloid hydraulic motor structure and functional characteristics

1, the use of inner hole and axial plane flow distribution, XWM8 series hydraulic motor structure is simple and compact, high precision flow distribution.

2, insert teeth fixed motor rotor pair, high mechanical energy, high pressure operation long service life.

3, the use of double Angle ball bearing, can carry a large tangential and radial load, sliding friction is small, high mechanical energy.

4, exquisite flow distribution organization design scheme, with high accuracy of flow distribution and damage automatic compensation characteristics.

5, cycloid hydraulic mada allows serial-parallel circuit application, serial-connected application of the oil leakage hole.

6, using deep groove ball bearing support point design scheme, CA50 series hydraulic motor has a great tangential bearing capacity, to promote the motor can simultaneously promote the work of the organization.

7, a variety of flange, output shaft, oil hole and other installation connection.

Two, cycloid hydraulic motor operation common problems

1. Check whether all components of the hydraulic transmission system are properly connected before operation, and add the oil to a specific relative height according to the filter element.

2. Start running for 10~15 minutes without load, and carry out the exhaust pipe and fuel tank with foam plastic, A2FE series hydraulic motor system software has noise, and the motor hydraulic cylinder has hysteresis confirm that there is gas in the system.

3. After removing the gas, fill the oil tank, and then gradually increase the load of the cycloid hydraulic motor until the special load, and check whether there are abnormal conditions, such as noise, oil rise and oil seepage.