Grasp the advantages of orbital motor from a professional perspective

Small in size and light in weight, it is much smaller than other types of hydraulic motors with the same torque.

First, the advantages of cycloid hydraulic motor:

1. Small and light in weight, its size is much smaller than other kinds of hydraulic motors with the same torque.

2. Wide coverage of speed ratio, infinitely variable speed, low and stable speed ratio up to 15 RPM, convenient installation layout, low project investment cost.

3, in the hydraulic transmission system can be connected to the application, also can be connected to the application.

4, rotary inertia force is small, it is very easy to start under load, positive and negative can be applied, and there is no need to shut down when switching

Two, cycloid hydraulic motor performance characteristics:

1, the use of inner hole and axial plane flow distribution, compact structure, high precision flow distribution;

2, insert teeth fixed motor rotor pair, high mechanical energy, high pressure operation long service life;

3, the use of double Angle ball bearing, can carry a large tangential and radial load, sliding friction is small, high mechanical energy.

4, high quality flow distribution organization design scheme, with high precision flow distribution and damage automatic compensation characteristics.

5, the motor allows series and parallel circuit application, series application of the oil leakage port.

6, the use of deep groove ball bearing support point design, with a large tangential bearing capacity, to promote the motor can simultaneously promote the work of the organization.

7, a variety of flange, output shaft, oil inlet and other installation connection.

Three, cycloid hydraulic motor operation common problems:

1. Check whether all components of the hydraulic transmission system are properly connected before operation, and add the oil to a specific relative height according to the filter element.

2. Start running for 10~15 minutes without load, and carry out the foam plastic in the exhaust pipe and fuel tank, XWM3 series hydraulic motor system software has noise, and the motor hydraulic cylinder has hysteresis, which confirms that there is gas in the system.

3. After removing the gas, fill the oil tank, and then gradually lift the load to the motor until a longer load, and check whether there are abnormal conditions, such as noise, oil rise and oil seepage, etc.